Direct Backplane Jumper Settings - Dell PowerEdge C6220 Hardware Owner's Manual

NOTE: The * in the table of system configuration jumper describes the default
status and the default state is not active state.

Direct Backplane Jumper Settings

CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came with
the product.
The function of jumpers installed on 3.5" HDD Direct Backplane and 2.5"
HDD Direct Backplane is the same. Following is an example using the
jumpers installed on 3.5" HDD Direct Backplane.
Figure 5-18. Jumper Installed on Direct Backplane
Table 5-2. Jumpers Installed on Direct Backplane
Jumper
SW1 (pin1-2)
SW2 (pin3-4)
SW3 (pin5-6)
SW4 (pin7-8)
NOTE: The * in the table of Direct Backplane jumper describes the default status
and the default state is not active state.
Function
Reserved
Reserved
SGPIO I 2 C Select
MFG Test
Off
*Disable
*Disable
*Disable
*Disable
Installing System Components | 309
On
Enable
Enable
Enable
Enable