Advertisement
STEP 3 (See Diagram 3)
A.) Two people to assemble this step are highly recommended. Do not tighten Nuts and
Bolts until instructed to do so.
B.) Attach the Left & Right Support (#8) & (#9) onto the open bracket one the Base Frame (#1).
Make sure the Front Support Base (#47) is placed in front of the Front Vertical Frame
(#2).
C.) Secure each Support to the bracket with two M8 x 5/8" Allen Bolts (#10), two Ø 5/8" Washers
(#4) from the side, four M8 x 5/8" Allen Bolts (#10), four Ø 5/8" Curved Washers (#11) from
front and rear.
D.) Attach the Inversion Retaining Strap (#18) to the opening on the Front Vertical Frame (#2).
Align the holes. Secure the Inversion Retaining Strap to the Front Vertical Frame with one M8
x 2 3/8" Allen Bolt (#17), two Ø 5/8" Washers (#4), and one M8 Aircraft Nut (#5).
E.) Securely tighten all Nuts and Bolts installed in Step-2 and Step-3.
F.) Cover the four M10 Aircraft Nuts (#7) with four Nut Caps (#15).
G.) Make sure the pivots can move smoothly.
7
DIAGRAM 3
Advertisement
