Receiver Information - Heath Zenith Secure Home 598-1347-00 Reference Manual

rECEIvEr INForMatIoN

All receivers have the following features and ratings:
• Rated for 120VAC/60Hz supply voltage.
• Not for use with Compact Fluorescent bulbs.
• When first turned on wait 15 seconds.
INdoor PLuG-IN CoNvErtEr
Features and Ratings:
• Up to 300 Watt maximum incandescent load.
• No wiring required.
1. Plug in indoor receiver.
2. Plug in light you wish to control.
CautIoN: do not exceed the maximum load limits
listed above.
3. Check operation. Activate transmitter being used with receiver
(see transmitter instructions). A signal will be sent to the receiver
to turn the receiver ON or OFF.
4. Using Remote By-Pass Switch. These receivers are equipped
with a remote by-pass switch. This switch allows the user to
select between AUTO and MANUAL modes. AUTO mode
allows the light to be operated by remote control or remote
motion sensor. MANUAL mode allows the plugged in light to
be operated manually.
5. Adjust audio alert volume. The alarm sounds only when the
receiver is activated by the wireless motion sensor and entry
switch. The alarm volume is adjusted by the thumbwheel on
the side of the receiver unit.
Speaker
Control Locations
Remote
By-Pass
Switch
Alarm Volume
Control
6
HaLoGEN FLoodLIGHt
• Bulb Saver™ - Extends bulb life by up to 4x standard bulbs.
Lights bulb to full bright in under 2 seconds.
• Install fixture in accordance with local codes.
CautIoN: Keep the sensor at least 2" (51 mm) away
from the bulbs.
CautIoN: to avoid Fire or Burn Hazards:
• Allow fixture to cool before touching. The bulb and the fixture
operate at high temperatures.
• Keep fixture at least 2" (51 mm) from combustible materials.
Do not aim at objects closer than 3' (1 m).
• Replacement Bulb - Use only T4 100W (max.), G8 tungsten
halogen bi-pin 120 VAC bulbs.
Bulb Installation and replacement
Note: Bulbs are included, but you will need to install them.
Note: When replacing bulbs, turn power off and let the fixture
cool.
• To remove lamp shade, loosen set screw 2 full turns with a
small flat-head screwdriver. Turn shade counterclockwise and
remove.
• To remove bulb, pull straight out of fixture.
• To replace bulb, push bulb pins into bulb socket. Check that the
bulb is seated properly.
• To reinstall lamp shade, place shade on fixture and align notches
on shade with tabs on fixture. Turn clockwise. Tighten set screw
firmly.
Features and Ratings:
• Up to 200 Watt Maximum Tung-
sten Halogen (Up to 100 Watt
Maximum each bulb holder.)
• Minimal wiring required.
598-1347-00