Battery Replacement; Specifications - Heath Zenith Motion Sensor Light 7101 Installation Manual

batterY rePLaceMent

This solar light contains a rechargeable battery that can
be replaced if needed. To replace the battery follow the
steps below.
IMPORTANT: the sealed lead-acid battery must be
recycled or disposed of properly.
1. Remove rear battery cover. Press in the two catch
releases on the cover and remove the cover.
2. Remove rechargeable battery. Slide battery out of case
and remove the wire connectors from the battery.
3. Replace battery. Connect the RED wire connector to
the positive (+) terminal and the BLACK wire connector
to the negative (-) terminal.
4. Replace battery cover. Insert the two tabs on the cover
into the slots on the back of the case. Press the cover
against the case until the two catch releases snap into
place.
IMPORTANT: keep sensor switch in the "OFF"
position for three days to allow the battery to fully
charge before testing.
Tab Slots
Rechargeable
Battery
Battery
Cover
Battery Cover Catch Release
598-1344-00
Range ........................... Up to 70 ft. (21 m); [varies with
Sensing Angle .............. Up to 180°
LED (x3) ....................... 7.8 watts
Battery Type .................. Sealed lead acid, 6 V 6.0 A-Hr.
On Time ........................ Test, 1 or 5 minutes, selectable
Full Charge on Time ..... Up to 1 hour
IMPORTANT: DO nOt reverse the battery wires. Dam-
age to the unit will result. Like any lead-acid battery,
this battery must be disposed of properly.
HeathCo LLC reserves the right to discontinue products
and to change specifications at any time without incurring
any obligation to incorporate new features in products
previously sold.
Positive Wire
Negative Wire
3

SPeciFicatiOnS

surrounding temperature]