Table of Contents
Advertisement
Auto Error – Override Printing
During normal printing if the AUTO CONT INUE, in the Level-2 menu, is set to ON,
if a software or data error occurs the printer will briefly display an error message, and
after a few seconds continue printing.
If the AUTO CONTINUE parameter is set to OFF, the factory default, when an error
is detected, the printer will stop printing. To resume printing the RECOVER button
must be pressed.
Darker/Lighter Print Quality
During normal printing darker or lighter print quality can be acheived by using the
DARKNESS CONTROL option in menu Level-2.
If you want darker print select +1 or +2 (darkest), if you want lighter print select -1 or
-2 (lightest).
Maintenance Menu Items
The printer Maintenance Menu Mode can be entered by switching on the printer while
holding the MENU1/Menu2 button. In this special mode, data received by the printer
can be analysed on the printed page, which will be in the form of a HEX dump.
You can reset all Level-1 menu items to the factory default setting when user default
settings become confused.
Also in this mode, the Image Drum life counter can be cleared when the Image Drum
unit has been replaced with a new one.
Level-1 Menu Reset to factory default
1. Switch on the printer while holding down the MENU1/Menu2 button. You will see
the message USR MNT (user maintenance) in the message window.
2. Press the MENU1/Menu2 button for less than two seconds to display the MENU
RESET message.
3. Press the ENTER/Power Save button to display the message MENU /RESET'NG
(resetting).
4. All the Level-1 menu items are now reset to the factory default setting, and the
printer is returned to the normal on-line mode.
Control Panel 1-5
Advertisement
Table of Contents
