Siemens Advance Network Gateway User Manual page 47

Editing the Address Translation Table,
Displaying the ATT
2000590-001
The Address Translation Table (ATT) can be displayed using the
Configuration Management routines.
1. Log on locally to the ANG_EN.
2. To display the entire ATT type at the Local
3. To display a single Loop only type: display adh x
Where x is the ADH Loop number. Allowable values are 1 - 8. If you
leave off the x value then the Loop number will default to the Loop
number of the local ANG_EN.
Continued
prompt: display all
Data Communications Setup 39