Setting Up Tv1 To Operate In Uhf Pro - Dish Network DP512 User Manual

Chapter 2
Receiver Description and Installation

Setting Up TV1 to Operate in UHF Pro

Page 34
You can set your receiver to operate TV1 using an optional IR/UHF Pro remote
control (an accessory sold separately) by completing the following instructions:
If you set up your receiver to operate tuner
any other UHF Pro remotes in the same building will interfere
with each other when operated at the same time. This may
prevent remotes from operating the receiver momentarily.
1. Perform the following using an existing remote control:
a. Open the
TV1 UHF Pro Setup
remote control.
b. Select from the
Enable
c. Select
System Info
d. Move the highlight to the address for the
shown below.
2. Perform the following steps using the UHF Pro remote that you are going to
use to control TV1:
a. Press and hold the SAT mode button about three seconds, until all the
mode buttons light up, and then release the SAT button. The SAT mode
button begins to blink.
b. Use the remote control NUMBER PAD buttons to enter any number
from 1 to 16. The SAT mode button blinks as you enter each digit, then
remains lit.
Write down the number you entered:
c. Press the POUND (#) button. If you entered the address correctly, the
SAT mode button will flash three times.
d. Press the RECORD button on the IR/UHF Pro remote control.
e. Make sure the
System Information
Remote Address
matches the number that you wrote down in step b.
screen by pressing MENU-6-1-6 on the
TV1 UHF Pro Setup
to open the
System Information
Primary Remote Address
Note: Highlight the
Primary Remote
Address.
screen shows that the
indicates
UHF Pro and IR
using UHF Pro,
screen.
screen.
as
Primary
, and that this address