Dish Network DP512 User Manual page 34

Chapter 2
Receiver Description and Installation
Phone Line Connection
Phone System Setup
Page 28
: You may be able to use a wireless modem jack. However,
Note
this may not support all the features of this receiver, such as Caller ID.
See information on www.mydish.com for compatible modem products.
: If you have Digital Subscriber Line (DSL) service, then you may have to
Note
install a DSL filter between the receiver's back panel PHONE JACK and the
telephone wall jack to successfully connect with DISH. You can obtain such a
filter from your DSL provider or local consumer-electronics parts store.
Run a telephone cable with a standard RJ-11 connector from the receiver's back
panel Phone jack to an active telephone connection.
You must also set up the receiver for your type of telephone system (touch-tone
or rotary/pulse dialing), and set a telephone number prefix, if you need to dial a
prefix to make an outside call.
1. Open the
Phone System
control.
2. Select the
Touch Tone
3. Select either the
No Prefix
list.
Prefix
: Usually, you need a telephone number prefix only for business-line
Note
installations. For most residential installations, all you need to do is set the
telephone system type. The default setting of
dialing. If this is the case, continue with step 4 and then stop. If you do need
to set a prefix, then instead of selecting the
4. If you selected the
No Prefix
5. If you selected the
Prefix
where you must enter the exact numerical sequence you must dial on the
phone to obtain an outside line.
6. After entering this prefix, highlight and select the
settings.
screen by pressing MENU-6-1-4 on your remote
or the option in the
Rotary/Pulse
or the option in the
Prefix Code
No Prefix
Done
option, select
Done
code option, then the receiver highlights the box
list.
Phone Type
Outside Line
will allow correct
option, skip to step 5.
to finish.
option to save these
Done