Table of Contents
Advertisement
Chapter 1
Introduction
Quick Tour of Watching One Program While
Recording Another
Page 16
The steps below show one of many ways to watch one program while
recording another.
1. Press GUIDE to open the
you want to watch now.
2. Press SELECT to watch that program.
3. Press the RECORD button.
4. Select
.
OK
5. Press the GUIDE button on the remote. Use the
another program that you want to watch now. Select that program. You
are now watching one program while recording another.
6. Press the RECORD button and select
displays. You are now recording two programs at the same time.
7. Press the DVR button on the remote control. The
will open. You should see the two current programs that are recording
indicated by the red dot next to the listings.
8. Select a program that you recorded in an earlier quick tour (that is, one
that is not recording now), and then select
9. You should now be watching a pre-recorded program while the receiver
is recording the other two.
*
: This feature is enabled only for those installations that have two
Note
RG-6 cables from the compatible LNBF or switch connected to both of the
receiver's
S
I
ATELLITE
N
with a single RG-6 cable connected to the receiver
*
. Find a program
Program Guide
when the pop-up message
OK
Start
ports. This feature is not supported for installations
to find
Program Guide
screen
DVR Events
.
port.
S
I
1
ATELLITE
N
Hide quick links:
Advertisement
Table of Contents
