The Receiver Back Panel - Dish Network DP111 User Manual

Chapter 2
Parts of the System
Tighten the
coaxial cable
connections only
by hand.
Tip: Using cable
labels makes it
easy to tell which
cables connect to
the right receiver
ports.
Tip: If you have the
receiver connected
to a DSL (Digital
Subscriber Line)
phone line and it
cannot dial out,
you may have to
install a DSL filter
between the
receiver and the
telephone jack on
the wall.
Page 6
T R B
HE ECEIVER ACK
The back panel of the receiver provides the connections that you use to connect
the receiver to other electronic devices. It also provides the receiver power cord
and telephone jack. Depending on the setup that you use, you may only use
some of these connections. For information on wiring and wiring diagrams, see
the installation instructions in Chapter 4.
C C
OAXIAL ONNECTIONS
The three coaxial connections on the back of your receiver are color coded.
When you install your receiver or if you ever have to move it, the color coding
will make it easier for you to connect the cables to the back of your receiver.
Inside the front cover of this guide are stickers that are color coded the same
way as the coaxial connections. See Chapter 4 for instructions on connecting
your receiver to other electronic devices using coaxial cables.
S I
ATELLITE N
Connect the coaxial cable between the satellite dish and the
receiver using this input. The S
color coded blue.
TV S O
ET UT
Connect the coaxial cable between the receiver and TV using this
input. The TV S
ET
TV A /C
NTENNA ABLE
If you connect a cable TV box or a broadcast TV antenna to the
receiver, use the back panel TV A
for the local signal. The TV A
color coded black. See TV/Video Button on page 8 for information
on how to use this input.
T J
ELEPHONE ACK
Connect a telephone cable with a standard RJ-11 telephone
connector to the receiver here, and then connect the cable to an
active telephone line.
Note: The receiver must be connected at all times to an active telephone line. If
you install two or more receivers, each receiver must be connected at all times to
an active telephone line.
P
ANEL
I
ATELLITE N
O
connection is color coded white.
UT
I
N
/C
NTENNA
/C
NTENNA ABLE
connection is
I
connection
ABLE N
I
connection is
N
TV ANTENNA
/CABLE IN