Table of Contents
Advertisement
3.
Holding the edge of the peripheral card, carefully align the edge
connector with the expansion slot.
4.
Push the card firmly into the slot. Push down on one end of the
expansion card, then the other. Use this "rocking" motion until the
add-on card is firmly seated inside the expansion slot.
5.
Secure the board with the mounting screw removed in Step 2. Make
sure that the card has been placed evenly and completely into the
expansion slot.
6.
Replace the computer system's cover.
7.
Setup the BIOS if necessary.
8.
Install the necessary software drivers for the expansion card.
5). Connect Devices
Floppy Diskette Drive Connector: FDD
This connector provides the connection with your floppy disk drive.
The red stripe of the ribbon cable must be the same side with the Pin 1.
Installation Procedures
2 - 15
Advertisement
Table of Contents
