3.
Push the card firmly into the slot. Push down on
one end of the expansion card, then the other.
Use this rocking motion until the card is firmly
seated inside the expansion slot. Secure the
card with the screw that was removed in Step2.
5). Connect Devices
Floppy Diskette Drive Connector
This connector provides the connection with
your floppy disk drive.
Insert the floppy ribbon cable (below) onto
the floppy connector.
The colored stripe (indicated by the arrow head, right) of the ribbon cable must be
the same side with the Pin 1.
PTM900 Mainboard Manual
2- 7