User Information; Service Menu; Maintenance; Cleaning - Dimplex QSH-70 Owner's Manual

Operation

User Information

Press and hold the selector dial for 5 seconds to
display the user information menu, three choices
are available:
SP Range - Adjustment of the temperature
range available
Factory - Returns all settings to the factory
presets – Yes or No.
Extra Charge - Adjustment to increase the
amount of energy stored

Service Menu

CAUTION: Changing the settings in the Ser-
vice Menu should ONLY be done by a SERVICE
TECHNICIAN as changes may affect the preferred
operation of the unit.
Press and hold the Menu, Back AND Selector dial
for 5 seconds to display the Service Menu, five op-
tions are available:
Configure - has three options within it:
Autoboost
• OFF determines how long the Advance
Boost option remains On.
• ON allows the Advance Boost option to
operate until the next indication of electri-
cal change.
Initial Charge – Determines whether an initial

Maintenance

Cleaning

WARNING: Disconnect circuit power before
attempting any maintenance or cleaning to
reduce the risk of electric shock or damage to
persons.
To maintain the external appearance of the heater
it needs to only to wiped over occasionally with a
dry cloth. During the summer months, or at other
times when the appliance is not in use and is
completely cold, the opportunity should be taken to
charge of 0% or 100% is needed.
Fan Speed - Adjustment of fan speed between
75% and 100% mainly used to reduce noise
control.
!
NOTE: A lower maximum fan speed results
in a lower maximum heater output.
RF Coms - Disables or enables communications
with the Quantum hub communication systems.
The letters seen at the bottom of this option
screen is the heaters unique identification num-
ber to used for communication setup.
Charge Time - Sets the standalone charge time.
When not connected to the Quantum hub, this
setting will be the core charging time.
Slave Mode - Used to run the heater at a con-
stant output. One heater in a space where there
are multiple heaters can be set in Slave Mode to
more efficiently heat the space.
Heater Size - Displays the capacity of the heater.
The capacity of the heater can be found on the
rating label on the outer shell of the heater.
!
NOTE: This setting should only be changed if
found to be incorrect.
wipe over with a damp cloth. Do not use abrasive
cleaning powers or furniture polish.
Discolouration of wall finished can sometimes oc-
cur immediately above a heater due to the proper-
ties of some paints and decorating materials or
the presence of environmental impurities in the air
such as soot or incense generated from the burn-
ing of candles, etc.)
13