Table of Contents
Advertisement
PPP General
PPP
Dial-on-Demand:
Idle Time Out:
Connect Time Out:
Dialing Max Retries:
Authentication
Authentication Type:
User Name:
Password:
ICMP Keep Alive Check
Keep Alive Check:
Keep Alive Type:
Host Name:
TCP Port:
Interval:
ICMP Count:
Modem Configuration
Baud Rate:
Dial Number:
Dial Prefix:
Connect String:
APN:
Init String:
Submit Button
Click the Submit button to save these settings.
completed and submitted all the screens on which you have made changes.
Multi-Tech Systems, Inc. MultiModem Wireless Modem with Ethernet Interface (S000375E)
Enable/disable PPP. The default is Enable.
Enable/disable Dial-on-Demand. The default is Enable. If you disable it, the modem
will always stay connected.
Set the amount of idle time that will pass before the modem will timeout. The
default is 180 seconds.
Set the number of seconds to wait for a connection while in receive mode before
timing out.
Enter the number of dialing retries allowed. The default is zero, which means an
infinite number is allowed. Range 0 to 100.
Set the authentication protocol type that will negotiate with the remote peer:
pap/chap/pap-chap. Default is pap-chap.
Enter the User Name with which the remote peer will authenticate. Default is
ipmodule. You can leave this field blank, if desired.
Enter the Password with which the remote peer will authenticate. Default is
ipmodule. You can leave this field blank, if desired.
Enable/disable Keep Alive Check. The default is Disable.
Select ICMP or TCP (the protocol type for Keep Alive).
Enter the Host Name or IP Address for Keep Alive Check. No default.
Enter the TCP Port number to connect with the TCP server.
Set the number of seconds for Keep Alive Check. Default is 30 seconds.
Set the number of ICMP Keep Alive Checks to be sent to the specified host. Default
is 10.
(Refer to the Customer Activation Notices included with the product for proper
information to enter).
Set the serial baud rate. Default is 115200.
Set the dial number to be dialed. Default is NULL.
For EDGE or GPRS the number is *99***1#.
For CDMA the number is #777.
Set the modem dial prefix. The default is ATDT.
Set the modem Connect String. The default is CONNECT.
For GPRS and EDGE, enter the APN (Access Point Name). The APN is assigned
by your wireless service provider.
Configure the modem init strings. You can set up to 4 modem initialization strings.
Note:
Chapter 3 – Using the Web Management Software
You must click Save and Restart once you have
29
Advertisement
Table of Contents
