Appliance Setup; Remove Clean Face Components; Remove Glass Assembly; Remove The Shipping Materials - Heatilator Direct Vent Gas Appliance CD4236MILR Owner's Manual

14 14

Appliance Setup

A. Remove Clean Face Components
B. Remove Glass Assembly
See Section 14.K.
C. Remove the Shipping Materials
Remove shipping materials from inside or underneath the
fi rebox.
D. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the fi rebox or underneath in the control cavity.
E. Accessories
Install approved accessories per instructions included
with accessories. Contact your dealer for a list of ap-
proved

accessories.

WARNING! Risk of Fire and Electric Shock! Use ONLY
Hearth & Home Technologies-approved optional acces-
sories with this appliance. Using non-listed accessories
could result in a safety hazard and will void the warranty.
54
Vermiculite and
lava rock
placement on
sides and front
of hearth pan.
Figure 14.1 Placement of Rockwool, Lava Rock, Vermiculite
Heatilator • Caliber Mesh CD Series-SIT Valve • 4040-849 Rev J • 06/08
F. Install the Refractory
A weathered brick refractory is available as an optional
accessory. Install the WTBC36D in the CD4236 Series
appliances and the WTBC42D in the CD4842 Series ap-
pliances. Follow the installation instructions provided with
the specifi c accessory part.
G. Place the Lava Rock
• See diagram, Figure 14.1.
H. Place the Vermiculite
• Sprinkle vermiculite over lava rock. See diagram,
Figure 14.1.
I. Place the Rockwool
WARNING! Risk of Explosion! Follow rockwool placement
instructions. DO NOT place rockwool directly over burner
ports. Replace rockwool material annually. Improperly placed
rockwool interferes with proper burner operation.
• Rockwool is shipped with this gas appliance.
• Place a small amount of 1/2 in. diameter pieces (dime0-
size) rockwool on the burner pan so that rockwool
touches but does not cover the holes in the burner
pan.
Rock wool
Vermiculite and
placement
lava rock
(shaded areas)
placement on
sides and front
of hearth pan.