Table of Contents
Advertisement
The Print Contrast values are:
1, 2, 3 (Factory Default Setting), 4 and 5.
The Form Smudging values are:
1, 2, 3 (Factory Default Setting), 4, 5 and 6
1 = least smudging (anvil in the lowest position).and
6 = most smudging (anvil in the highest position).
The Psbk Smudging values are:
1, 2, 3 (Factory Default Setting) 4, 5 and 6
1 = least smudging (anvil in the lowest position).and
6 = most smudging (anvil in the highest position).
The Top Offset values are:
0
=
0.1in (2.54mm) Factory Default Setting
Note: Mechanical Top Margin = Top Offset
1
=
Up to 0.6in (13.3mm)
2
=
Up to 1.1in (27.94mm)
3
=
Up to 1.6in (40.64mm)
4
=
Up to 2.1in (53.34mm)
The printer uses an Optical Sensor to measure width. During the measuring process,
the sensor must not cross a black area. Therefore, if a Form or Envelope is
preprinted with a black area on the near the top of the document, such as a Logo or
Letter Head, a Top Offset must be set so that the width is measured in an area free
of black.
Measure the Black Border and use one of the values.
Setup
3-14
Advertisement
Table of Contents
