Table of Contents
Advertisement
3.2.4
Printing the Current Settings
This is done from the VIEW point.
Prerequisite 1: Loading a Document has been performed.
Prerequisite 2: Moving to VIEW has been performed.
1. Button Bar
-
Note: When printing has finished the document will be ejected forward over the
Document Guide.
3.2.5
Changing a Setting
In the following example the Print Quality parameter is changed from the factory
default Value of DRAFT to HQD (High Quality Draft).
1. Enter Setup
2. Load a Blank Document
3. Tab Horizontally, TWICE
4. Select IBM
Print functions follow and the list, CURRENT SETTINGS, will be visible.
5. Tab Vertically, 2 TIMES
6. Tab Horizontally, 2 TIMES
LOAD the selection
HQD is printed between FONT and DRAFT and the Skid performs a
vertical tab.
7.
Tab Vertically, 8 TIMES
8.
Tab Horizontally, 1 TIME
9.
Button Bar
The new configuration is stored, print functions follow and the document
is returned forward over the document guide.
Setup
press and hold down until the document
is advanced and printing begins.
-
perform Entering Setup.
-
perform Loading a Blank
Document.
-
the Skid points to the IBM Menu.
-
press and hold down the Button
Bar until the engine runs and the
document moves,
-
the FONT values DRAFT and
HQD are visible.
-
the Skid points to <>HQD.
-
press and hold down the Button
Bar until the engine runs and
the document moves,
-
the CONFIRM values, yes and
no are visible.
-
the Skid points to the 'yes' option.
-
press for longer than 2 seconds,
3-8
Advertisement
Table of Contents
