Table of Contents
Advertisement
3.4.4
<>DFT Menu
The Horizontal Alignment of a printed line in bi-directional DRAFT (DFT) can be
adjusted. This is done in two steps, DRAFT COARSE and DRAFT FINE.
1. Print the <>DFT menu settings.
2. Look at the printout and chose the DRAFT COARSE and DRAFT FINE
settings, indicated on the same line in the left most column, where you judge the
character overlap to be the best.
The Draft Coarse values are:
1, 2, 3 (Factory Default Setting), 4, 5 and 6.
This define the printing speed in steps.
Draft Fine
1 (Factory Default Setting), 2, 3 and 4.
This define the printing speed in firing units.
3.4.5
<>HQD Menu
The Horizontal Alignment of a printed line in bi-directional HIGH QUALITY
DRAFT (HQD) can be adjusted. This is done in two steps, HQD COARSE and
HQD FINE.
Perform the following:
1. Print the <>HQD menu settings.
2. Look at the printout and chose the HQD COARSE and HQD FINE settings,
indicated on the same line in the left most column, where you judge the
character overlap to be the best.
The HQD Coarse values are:
1, 2, 3 (Factory Default Setting), 4, 5 and 6.
This define the printing speed in steps:
HQD Fine
1 (Factory Default Setting), 2, 3 and 4.
This define the printing speed in firing units:
Setup
3-18
Advertisement
Table of Contents
