Table of Contents
Advertisement
Step 7
Gas Pressure
Requirements
______________________________________________________________
Inlet Pressure
Manifold Pressure
Gas Rate
Max.Input(NETCV)
Burner Injector
Pilot Injector
Step 8
Wiring the
Fireplace
Optional Accessories
Optional remote control
kits require that 230 VAC
be wired to the factory in-
stalled junction box be-
fore the fireplace is per-
manently installed.
Wall Switch
Position the wall switch in the desired position on a wall. Run a maximum of 780cm
or less length of 0.102 cm diameter minimum wire and connect it to the fireplace
ON/OFF switch pigtails.
Pressure requirements for Heat & Glo gas fireplaces
are shown in the table below.
Natural Gas Propane
(G20)
(G31)
20mbar
37 or 50mbar 30 or 50mbar 25mbar
4-8.7mbar
15.7-25mbar 15.7-25mbar 4-8.7mbar
m 3
m 3
.54
/
.24
/
h
h
10.0 kW
10.0 kW
DMS 33
1.8 mm
51
30
A tap is provided on the outlet side of the gas control
for a test gauge connection to measure the manifold
pressure. To measure inlet pressure, provisions
must be made to attach a test gauge to the tap
immediately upstream of the gas supply connection
to the fireplace.
The fireplace and its individual shut-off valve must be
disconnected from the gas supply piping system
during any pressure testing of the system at test
pressures in excess of 60 mbar.
If the fireplace must be isolated from the gas supply
piping system by closing an individual shut-off valve,
it must be of the handle-less type.
NOTE: Electrical wiring must be installed by a
competent electrician.
For Standing Pilot Ignition Wiring
Appliance Requirements
WARNING: DO NOT CONNECT 230 VAC
!
TO THE GAS CONTROL VALVE OR THE
APPLIANCE WILL MALFUNCTION AND THE
VALVE WILL BE DESTROYED.
Butane
Natural Gas
(G30)
(G25)
m 3
m3
.16
/
.54
/
h
9.5 kW
8.5 kW
DMS 51
DMS 33
30
51
h
31
Advertisement
Table of Contents
