NETGEAR WGR614v11 User Manual page 90

4. If you have enabled WPS security, verify that the push-button stops blinking and changes to
green (otherwise the push-button light should be off).
If the correct behavior does not occur, see the appropriate following section.
The Power light is not on.
If the Power and other lights are off when your router is turned on:
• Make sure that the power cord is properly connected to your router and that the power
adapter is properly connected to a functioning power outlet.
• Check that you are using the power adapter supplied by NETGEAR for this product.
If the error persists, you have a hardware problem and should contact Technical Support.
The Power light blinks green slowly and continuously.
The router firmware is corrupted.
To restore your firmware:
1. Make sure your PC is connected to your router and the router is powered on.
2. Insert the Resource CD that came with your router into your PC.
a. The CD will automatically start and detect the language you are using on your PC.
Select a different language option, if you prefer.
b. If the CD does not automatically start, browse the CD and double-click on
3. Click Supporting Software, then Netgear Firmware Recovery Utility, and follow the
prompts for the recovery process.
4. After firmware recovery is completed, follow the prompts to restore your configuration
settings.
The Power light stays amber.
When the router is turned on, the Power light turns amber for about 20 seconds and then
turns green. If the light does not turn green, the router has a problem.
If the Power light is still amber 1 minute after turning on power to the router:
1. Turn the power off and back on to see if the router recovers.
2. Clear the router's configuration to factory defaults. This will set the router's IP address to
www.routerlogin.net. This procedure is explained in
Password on page 97.
If the error persists, you might have a hardware problem and should contact Technical
Support.
The Internet light stays amber.
When the router is turned on, the Internet light turns amber for about 20 seconds and then
turns green. If the light does not turn green, the router has a problem.
90 | Chapter 7. Troubleshooting
N150 Wireless Router WGR614v11 User Manual
Restoring the Default Configuration and
.