Connecting Additional Wireless Client Devices After Wps Setup; Adding More Wps Clients; Adding Both Wps And Non-Wps Clients - NETGEAR WNR2200 User Manual

Connecting Additional Wireless Client Devices After WPS
Setup
You can add more WPS clients to your wireless network, or you can add a combination of WPS-
enabled clients and clients without WPS.

Adding More WPS Clients

Note: Your wireless settings remain the same when you add another WPS-enabled client,
as long as the Keep Existing Wireless Settings check box is selected in the
Advanced Wireless screen (listed under the Advanced heading in the wireless
router main menu). If you clear this check box, when you add the client, a new
SSID and passphrase will be generated, and all existing connected wireless clients
will be disassociated and disconnected from the wireless router.
To add a wireless client device that is WPS-enabled:
1. Follow the procedures in
PIN Entry to Add a WPS Client" on page
2. To view a list of all devices connected to your wireless router (including wireless and
Ethernet-connected), see

Adding Both WPS and Non-WPS Clients

For non-WPS clients, you cannot use the WPS setup procedures to add them to the wireless
network. You must record, and then manually enter your security settings (see
Configuring Your Wireless Settings" on page
To connect a combination of non-WPS enabled and WPS-Enabled clients to the wireless router:
1. Restore the wireless router to its factory default settings (press and hold the Reset button on
the back of the router for 5 seconds).
When the factory settings are restored, all existing wireless clients are disassociated and
disconnected from the wireless router.
2. Configure the network names (SSIDs), select the WPA/PSK + WPA2/PSK radio button on the
Wireless Settings screen (see
and click Apply. On the WPA/PSK + WPA2/PSK screen, select a passphrase and click Apply.
Record this information to add additional clients.
Safeguarding Your Network
N300 Wireless Router with USB WNR2200 User Manual
"Using a WPS Button to Add a WPS Client" on page 3-13
3-14.
"Viewing a List of Attached Devices" on page
3-4).
"Manually Configuring Your Wireless Settings" on page
v1.0, May 2011
or "Using
5-9.
"Manually
3-4).
3-17