Washer Fluid Check; Technical Specifications - Ford Mondeo Owner's Handbook Manual

CAUTION
Do not top up further than the MAX
mark.
Top up with fluid that meets the Ford
specification. See Technical
specifications (page 194).

TECHNICAL SPECIFICATIONS

Vehicle fluids
Item
Engine oil
Power steering fluid
Coolant
Brake fluid
Do not use oils which do not meet the specifications or requirements. Use of
unsuitable oil may lead to engine damage which is not covered by your Warranty.
*
You can use an alternative SAE 5W-30 engine oil, providing it meets the specification
defined by WSS-M2C913-B.
Note: If you operate your vehicle in temperatures below -20°C (-4°F ), you must not
use SAE 10W-40 engine oil.
Topping up the oil: If you are unable to find an oil that meets the specification defined
by WSS-M2C913-B, you must use SAE 5W-30 (preferred), SAE 5W-40 or SAE
10W-40 that meets the specification defined by either ACEA A1/B1 (preferred) or
ACEA A3/B3. Using these oils can result in longer engine cranking periods, reduced
engine performance, reduced fuel economy and increased emission levels.
Capacities
Variant
All
Maintenance

WASHER FLUID CHECK

Note: The front and rear washer systems
are supplied from the same reservoir.
Recommended fluid
Ford or Motorcraft
Formula E SAE 5W-30
*
Engine Oil
Ford or Motorcraft Power
Steering Fluid
Motorcraft SuperPlus Anti-
freeze
Ford or Motorcraft Super
DOT 4 Brake Fluid
CAUTION
Item
Power steering system
194
Specification
WSS-M2C913-B
WSS-M2C204-A2
WSS-M97B44-D
ESD-M6C57-A
Capacity in litres (gallons)
MAX mark