Pairing The Remote Control With The Console; Resetting The System; Performing A System Update; Contacting Customer Service - Bose VideoWave III Operating Manual

Pairing the remote control with the console

1.
Hold the remote control close to the control console.
2.
Press and hold both the Mute button
sole and the OK button on the remote control at the same
time for five seconds. The control console system status
light blinks when pairing is complete.
3. Press any remote control button and verify that the control
console system status light on the control console blinks
with each button press.

Resetting the system

1. Press and hold the Power button
for five seconds, or until the color of the control console
system status light goes off.
2. Release the Power button and the system restarts. When
the control console system status light changes from blink-
ing green to solid green, the system is on and ready to use.
3. If you still cannot operate the system using the remote con-
trol, please follow the steps in "Pairing the remote control
with the console" on this page.
on the control con-
on the control console

Performing a system update

System software updates from Bose can be installed by follow-
ing these instructions:
1. Press the Setup button on the front of the control console to
display the UNIFY menu.
®
2.
Using the remote control navigation buttons, select
"Update."
3. Follow the instructions on the screen.

Contacting customer service

For additional help in solving problems, contact Bose
Service. See the address sheet included in the box.
Troubleshooting
Customer
®
English - 33