Entering Address Without Knowing District Or Suburb - Eclipse AVN726EA Owner's Manual

Navigation Guidance
Navigation Guidance
6
Touch [<Street Name>].
● Start entering the street name on the
keyboard.
● After entering a couple of characters, the
names that match the string appear in a
list.
● Touch [Done] to open a list of results
before one appears automatically.
7
Select the street from the list.
8
Touch [<House Number>].
● Enter the house number on the keyboard.
Touch [Done] to finish entering the
9
address.
A list appears with the matching
10
addresses. Touch the desired one.
The map appears with the selected
11
point in the middle. From the Cursor
menu, touch [Set as Destination]
(Advanced mode). The route is then
automatically calculated, and you can
start navigating.
92
92
■ Entering
address
knowing district or suburb
Long roads can run across several districts or
suburbs. You may not know what particular
house number is located where. In this case,
follow the instructions below.
Touch the following switches: [Find],
1
[Find Address] (Advanced mode).
By default, Navigation proposes the
2
country/state and city where you are. If
needed, touch the switch with the
name of the country/state, and select a
different one from the list.
3
If needed, change the city.
● To select the city from the list of recently
used ones, touch the
Touch the following switches. After
4
changing the country/state, touch
[<Enter Suburb/Town Name>].
● Start entering the city name on the key
board.
● After entering a couple of characters, the
names that match the string appear in a
list.
● Touch [Done] to open a list of results
before one appears automatically.
5
Pick the city from the list.
without
switch.