Table of Contents
Advertisement
Other control screens
There are a number of dedicated menus and screens
available, which are accessed with the following
keys. These are all described in the appropriate sec-
tions of this manual:
Selecting parameters
If there are many parameters on a screen, use the cur-
sor keys to highlight the parameter you want to
change before setting the value with the dial.
Here, the two
values can be highlighted, and
changed with the dial. In the example above, the pan
value of channel 1 is highlighted for editing.
Setting values
When a value is to be changed, use the
dial to change the value.
The
key is often used as a "yes" key to
ENTER
answer questions like
which may sometimes be shown on screen (for
example, the screen below).
2 – Getting started–About the menus
EQ
SEND
FADER/PAN
TRACK CUE Off-disk level and pan positioning for cue mix
QUICK
SETUP
EFFECT 1
EFFECT 2
LOCATE
TRACK EDIT "Copy and paste", etc. of recorded material
UNDO/REDO Menu to undo or redo editing operations
STEREO
SUB MIX
TRACK
Sometimes there are "tabs" at the top of the screen.
Use the Ó and Á cursor keys to select the tab where
you will be making the change.
Here, the left and right keys are used to select the tab
from
selected in this screen).
The virtual tracks are then selected with the dial.
If you change your mind about carrying out an opera-
JOG/DATA
tion, use the
The
EXIT
answer on-screen questions.
Channel equalization
Channel Aux and Effect send
Channel fader and pan settings
Preset routing options, scene read and write,
routing assignment read and write
Effect selection and parameters
Effect selection and parameters
Location recall, naming and time viewing
Stereo section settings
Sub-mixer settings
Virtual track assignment
through
at the top of the screen (tab 1 is
key.
EXIT
key can also be used as a "no" key to
TASCAM 788 Digital PortaStudio
25
Hide quick links:
Advertisement
Table of Contents
