Mass Storage; Analog Audio I/O; Audio Specifications; Error Messages, Etc - Tascam 788 Owner's Manual

13 – Specifications, etc.–Error messages, etc.

Mass storage

External connector
Internal hard disk SCSI ID
Internal controller SCSI ID
Partitions
Partition size
Data format

Analog audio I/O

INPUT A through D
MIC/GUITAR switch (INPUT D only)
AUX INPUT
STEREO OUTPUT
MONITOR OUTPUT
AUX OUTPUT
PHONES

Audio specifications

Frequency response (INPUT to analog
STEREO OUTPUT)
Noise level (One INPUT to analog STEREO
OUTPUT)
Total harmonic distortion (INPUT to analog
STEREO OUTPUT)

Error messages, etc.

The following is a list of error messages that may be
displayed by the 788, together with a note of their
Message
120
TASCAM 788 Digital PortaStudio
SCSI-2 female
0
7
Up to 4 per physical disk
512 MB, 1 GB, 2 GB, 4 GB
TASCAM original format
1/4" balanced phone jacks, nominal level –50 dBu MIC, +4 dBu LINE, nominal impedance
4.0 kΩ (MIC/GUITAR at MIC)
Changes input impedance between 4.0 kΩ and 1 MΩ
1/4" unbalanced jacks, nominal level –10 dBV, nominal impedance 15 kΩ
RCA jacks, nominal level –10 dBV, maximum output level +6 dBV
RCA jacks, nominal level –10 dBV, output impedance 820 Ω
1/4" unbalanced jacks, nominal level –10 dBV, output impedance 820 Ω,
1/4" stereo jack, 60 mW + 60 mW approx. (load impedance 30 Ω)
20 Hz – 20 kHz ±1 dB
<82 dBV (input terminated at 150 Ω )
<0.01% at 1kHz, maximum input level with 400 Hz HPF and 22 kHz LPF
Meaning
This message appears if you try to finalize a
CD that is blank.
When writing a CD, the finalize operation was
not correctly performed.
If you are trying to do a multi-song CD record-
ing, this message appears if data already exists
on the CD.
This message only appears if a CD-RW drive is
connected to the 788. It appears if you are
attempting a backup operation to a CD-RW
disc, and the disc you have inserted for backup
is not blank.
There is no disc inserted for a CD operation
(play, write, finalize, backup or restore).
possible cause, and the actions you can take when
they occur.
Action
There is no point in finalizing a blank disc.
Insert the correct disc and try again.
Press EXIT / NO to make this message go
away and stop the procedure.
Try again with another disc. If this message
appears continually, consult the documentation
of your CD-R drive — the drive may require
attention.
Either write one song at a time, or use a new,
blank CD.
YES to erase the whole contents of the
Press
CD-RW disc and continue with the backup.
Press NO to cancel the operation.
Load a suitable disc and continue.