Preventing Damage To The Writing Surface - Smart Technologies SMART Board 3000i Installation Manual

Lamp Mode
Two lamp modes are available: the default (and recommended) Normal mode (100% brightness)
and Eco mode (80% brightness). Eco mode is dimmer than Normal mode, but offers increased
lamp longevity and conserves power.
Projector Power
Put the projector into standby mode at the end of each session by pressing the Projector
Standby button on the 3000i Control Panel. However, if you don't intend to use the projector for
an extended period, turn it off and then unplug it.
CAUTION: Do not turn off the projector and then immediately turn it back on. The projector
needs to cool for a minute before it can be restarted. After the projector turns off, the cooling
fans keep operating for a full minute, so don't unplug it during this time.

Preventing Damage to the Writing Surface

While the interactive whiteboard is very durable, sharp objects can scratch or cut the surface.
Sharp writing instruments, such as ballpoint or fine-point pens, can damage the surface if
enough pressure is applied. Keep these types of pens away from the interactive whiteboard and
avoid abrasive erasers and cleaning materials.
iv
Important Information