Table of Contents
Advertisement
Available languages
Available languages
3. Attach lower duct covers using a plastic bracket at each
corner (4 needed).
A. Upper duct cover
B. Lower duct cover
C. Plastic bracket
The range hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the hood
before cooking and allow it to operate several minutes after the
cooking is complete to clear all smoke and odors from the
kitchen.
The range hood controls are located on the front side of the
canopy.
A
B
C
D
A. Louver holes (non-vented
[recirculating] installations only)
B. Duct covers
C. Lamp housings
A
B
C
RANGE HOOD USE
G
E
D. Canopy
E. Grease filters
F. Grease filter handles
G. Control panel
Complete Installation
1. For non-vented (recirculating) installations only, install
charcoal filters over grille on blower housing. See the "Range
Hood Care" section.
2. Install metal filters. See the "Range Hood Care" section.
3. Check the operation of the range hood blower and light. See
the "Range Hood Use" section.
If range hood does not operate, check to see whether a
circuit breaker has tripped or a household fuse has blown.
NOTE: To get the most efficient use from your new range hood,
read the "Range Hood Use" section.
Control Panel
A
B
Grease Filter Saturation Alarm
After 30 hours of fan operation, the display will show "Clean
Grease Filter" when the fan is active. When this icon shows in the
display, the installed grease filters should be washed. See
"Range Hood Care" section.
F
To reset the grease filter saturation alarm, press and hold the
POWER INCREASE button for 5 seconds. The "Clean Grease
Filter" icon will no longer be displayed.
C
A. Power decrease
B. Power increase
C. Display
D. Light
E. Timer
Display
D
E
9
Advertisement
Table of Contents
