4.17 PHONES/CTRL ROOM Control
This control sets the amount of signal sent to the control room and headphone.
4.18 2TK IN/OUT Connectors
-. TAPE IN
Use the tape input if you wish to listen to your mix from a taper
recorder or DAT. You can assign the signal coming from the taper
recorder either to a pair of studio monitor using the control room
assignment on the front panel or you can also send the signal
directly to the main mix.
-. TAPE OUT
These RCA jacks will route the main mix into a tape recorder.
4.19 PHONES
This 1/4" socket will send out the mix signal to a pair of head-
phones.
4.20 AUX SENDS Connector
This 1/4" socket is used to send out the signal from the AUX bus
to external devices such effects.
4.21 STEREO AUX RETURNS Connectors
Use the stereo 1/4" sockets to return the sound of an effect unit
to the main mix. You can also use them as the extra auxiliary
inputs.
4.22 CTRL ROOM OUTPUT Connectors
These 1/4" sockets are used to send the control room signal to
the studio monitor speakers or a second set of PA.
4.23 MAIN MIX OUTPUT Connectors
The stereo output is supplied with 1/4" TRS sockets, which is used
to send the audio signal to an amplifier.
Through the main mix level control, you can adjust the output level
from -
to +15dB.
21
22
23
24
24
25
26
27
12
2-TRACK IN/OUT
L
R
TAPE IN
TAPE OUT
22
23
26
PHONES
MAIN MIX OUTPUT
27
26
AUX SENDS
LEFT
RIGHT
STEREO AUX RETURNS
CTRL ROOM OUTPUT
LEFT(MONO)
LEFT
RIGHT
RIGHT
25
27