Ctrl Room Output Connectors; 2Tk In/Out Connectors; Aux Sends Connectors; Phones - Alto AMX-120 User Manual

-. PHONES/CTRL ROOM Control
This control sets the amount of signal sent to the control room and headphone.

4.4 CTRL ROOM OUTPUT Connectors

These 1/4" sockets are used to send the control room signal to
the studio monitor speakers or a second set of PA.

4.5 2TK IN/OUT Connectors

-. TAPE IN
Use the tape input if you wish to listen to your mix from a taper
recorder or DAT. You can assign the signal coming from the taper
recorder either to a pair of studio monitor using the control room
assignment on the front panel or you can also send the signal
directly to the main mix.
-. TAPE OUT
These RCA jacks will route the main mix into a tape recorder.
4.6 AUX SENDS Connector
These 1/4" sockets are used to send out the signal from the AUX
bus to external devices such effects.

4.7 PHONES

This socket will send out the mix signal to a pair of headphones.

4.8 MAIN MIX OUTPUT Connectors

The stereo output is supplied with 1/4" TRS sockets, which is used
to send the audio signal to an amplifier.
Through the main mix level control, you can adjust the output level
from - to +15dB.
25
26
27
23
24
28
11
CTRL ROOM OUTPUT
L R
2-TRACK IN/OUT
L
R
TAPE IN TAPE OUT
AUX SENDS MAIN MIX OUTPUT
PHONES
LEFT
26 27
24
25
RIGHT
28