Table of Contents
Advertisement
INPUTS
1.
MONO INPUTS – Connect a microphone or line level instrument to these inputs using
standard XLR or ¼" cable.
2.
MONO Channel INSERT - Connect external sound processors such as compressor-limiter,
equalizers, etc. The Insert sockets can be used as direct-outs to feed the input of a 4-track
tape recorder.
3.
STEREO INPUTS-
Stereo pair ¼" TRS
input will operate in mono mode, (the mono signal will appear on both input channels).
CHANNEL CONTROLS
4.
PHANTOM PWR Switch - Applies +48 Volt Phantom Power only to the XLR MIC input.
When condenser microphones are not used, make sure that the Phantom Power is
disengaged.
5.
MONO IN GAIN – Adjusts the signal for mic and line level sources.
6.
LEVEL LED – Activates when there is an incoming signal.
7.
LOW CUT Button - Activates a 75 Hz low frequency filter to reduce hum noise or
microphone rumble.
8.
STEREO IN GAIN – Adjusts gain for the stereo line level channels.
connections.
If you connect only to the left jack, the
3
MIC 1
1
LINE IN
2
INSERT
1
LINE IN 9
3
LINE IN 10
4
+48V (CH1-4)
6
1
5
-30dB
+15dB LINE
0dB
+44dB MIC
7
LOW CUT
75HZ
18dB/OCT
8
Advertisement
Table of Contents
