Denon POA-3012CI - Multi-Zone Audio Distribution Power Amplifier Owner's Manual page 31

COMMAND and PARAMETER list
CGHAND CHANNEL PARAME7ER function example
PW 00
ON POWER ON/STANDBY change PWOOON<CR>
STANDBY PWOOSTANDBY<CR>
? Return PW Status PWOO?<CR>
SV
*01-12 UP CHANNEL VOLUME UP/DOWN , direct change to **dB SVOlUP<CR>
DOWN
SV01DOWN<CR>
**
**:00 to 99 by ASCII , 90=OdB, 99=---(MIN) SV0180<CR>
? Return channel volume Status SV01?<CR>
SO
02-12 (EVEN) NOR Operation mode NORMAL/BRIDGED change S002NOR<CR>
BRI S002BRI<CR>
? Return operation mode status S002?<CR>
SF *01-12
OFF Channel Low Cut Filter OFF/ON change SFOSOFF<CR>
ON SFOSON<CR>
? Return channel Low Cut Filter status SFOS?<CR>
SI *01-12 BUSL Select input "BUS L" SI06BUSL<CR>
BUSR BUS R SI06BUSR<CR>
BUSM BUS MONO (L+R) SI06BUSM<CR>
AUX AUX SI06AUX<CR>
? Return channel Input status SI06?<CR>
ST 02-12 (EVEN) CONT constant ST08CONT<CR>
TRIG Trigger in
ST08TRIG<CR>
ASIG Audio signal ST08ASIG<CR>
OFF Off ST080FF<CR>
? Return Zone Turn On status ST08?<CR>
00 PBTN Power button STOOPBTN<CR>
TRIG MASTER TRIGGER
STOOTRIG<CR>
ONLI
ON LINE STOOONLI<CR>
?
Return Power ON status STOO?<CR>
SV
CGHAND :
"*"
parameter uses two or three ASCII characters. (see page6 D) section)
*01-12 : The ZONE that "Normal mode" was selected, odd and even
CHANNEL
selectable.
I f
the ZONE that "BRIDGED mode" was
selected, only an even number
CHANNEL
selectable.
- 7 -