Denon POA-3012CI - Multi-Zone Audio Distribution Power Amplifier Owner's Manual page 21

ENGLISH
I
Re§ettingthe~icroproce"()r
PerfQrmthis procedl.lI'e
jf
the' qisplCiyisabnormal:or.jf
oper~tions
cannot
tJep~rforme(L
' ' • . ',;\
.
VYn~e.lh~
h;li
c
r
o procE! ss
9[
is;
[e~et.,~II.t6e,settiOQs.;arEl
"reseHgthekclefCl\.lltvaJue s ,:\,' . : , ' . . .
To use the web control function. set the menu "Main Setup"- "POWER
CONFIGURATION" - "ON LINE" ((Fpage 14).
'~[.jj.
• To perform web control. you must connect a web control device
such as a PC to the same network as the POA-30 12CI.
• With web control. some network settings. etc., cannot be set.
• When updating firmware. settings made by the web controller may
be reset.
1
Unplug the power cord from the power outlet.
If in step 3 the could not be start over from step 1.
2
Connect the power cord to the power outlet while
simultaneously pressing the
ZONE 5
and DISPLAY
buttons.
3
When all Zone operation mode indicators are
illuminated in
red and "
*
EEPROM INIT.
*..
is
displayed. release finger from two buttons.
(Example: 5]
Option Setup Screen
(Example: 3]
Warning and Protection Data Screen
(Example: 4]
Audio Signal and Trigger Input Screen
Enter figures or click u<
U
or u>u to make
the setting. and then click
USet~
(Example: 2]
System Setup Screen
*
:Normally. there is a change to the latest information each time
you operate. When operated from the main unit, click because the
screen is not updated.
5
Operate.
(Example: 1]
Channel Setup Screen
18