General Care Of The Wireless Ip Telephones And Chargers - Avaya 3616 Series User Manual

Avaya Inc.
General Care of the Wireless IP Telephones and
Chargers
Do not drop Avoid dropping the Wireless IP Telephone or knocking it against
Do not disassemble There are no serviceable parts in the Wireless IP Telephone or
Cleaning tips Turn off the Wireless IP Telephone and unplug the chargers before
Headset connector
cleaning
21-300629, Issue 1, July 2005
Avaya 3616/3620/3626 Wireless IP Telephone User Guide
This section applies to all Wireless IP Telephones and all Avaya
chargers.
hard surfaces. Carrying the Wireless IP Telephone in a holster or
carrying case will help to protect it.
chargers. You should not open the Wireless IP Telephone case nor
disassemble the chargers. Doing so will void your warranty.
you clean them. Never immerse either in water. Clean the exterior
surfaces, including the charging contacts, with a cloth that has been
slightly moistened with water. Take care not to exert undue
pressure on charger electrical contacts while wiping.
Wiping the handset surface with a water-dampened cloth or paper
towel will remove most films or residues. If the soiling is too
stubborn for plain water, a mild detergent solution may be used. Be
sure to wipe away any detergent residue with a clean water-
dampened cloth.
The Wireless IP Telephone may be cleaned with any general-
purpose household glass and surface-type cleaner. DO NOT
SPRAY THE HANDSET DIRECTLY!
Pre-treated cloths such as used for eyeglasses or cameras may be
used to clean the handset and Docking Station. Pre-moistened
towelettes may also be used to clean the phone, however, avoid
those containing lanolin or aloe as it will leave a slippery residue.
The surface of the handset may be cleaned occasionally with
disinfectants used for general cleaning in a medical
environment. Isopropyl alcohol may be used occasionally
applied by a damp cloth or paper towel. When using alcohol, do
not rub the keypad characters vigorously. Doing so will
significantly degrade legibility.
•
Do not use furniture polishes, waxes or plasticizer-based
cleaner (Armor All™, etc.)
•
Do not use lanolin, aloe, glycerin or other skin care type
products.
•
Do not apply any solvent such as acetone, mineral
spirits etc.
•
Do not directly spray or immerse the handset.
Should the headset connector become dirty, a scratchy or
intermittent signal may be experienced. To clean the connector,
dip the non-padded end of either a wooden or paper handled
cotton swab in isopropyl alcohol. Gently insert in the connector
and twist, repeating several times. If available, blow
compressed air into the connector to clear debris.
Page 27