Assembly - Pro-Form PFTL11011.0 User Manual

ASSEMBLY

• T o hire a service technician to assemble this
product in your home, call 1-800-445-2480.
• A ssembly requires two persons.
• P lace all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you finish all assembly steps.
• A fter shipping, there may be an oily substance
on the exterior of the treadmill or on the shipping
carton. This is normal. If there is an oily sub-
stance on the treadmill, wipe it off with a soft cloth
and a mild, non-abrasive cleaner.
1. Make sure that the power cord is unplugged.
Place a piece of cardboard below the rear of the
Frame (56) to protect the floor or carpet.
Attach the Left Wheel Cap (96) to the Base (94)
with two #8 x 3/4" Screws (2).
Attach the Right Wheel Cap (not shown) to
the right side of the Base (94) in the same
way.
2. Pull the Upright Wire (81) and the base ground
wire (A) through the indicated hole in the
Base (94).
Attach the base ground wire (A) to the Base (94)
with a #8 x 1/2" Ground Screw (10).
• T o identify small parts, see page 6.
• A ssembly requires the following tools:
the included hex keys
one adjustable wrench
one Phillips screwdriver
a pair of scissors
To avoid damaging parts, do not use power tools.
1
94
2
2
Hole
81
10
7
56
96
Cardboard
A
94