Table of Contents
Advertisement
Batteries and charging
Off Board Battery Charger
Your scooter is supplied with an off-board charging facility. Please note that
only chargers with a capacity of minimum 1.5 Amp and maximum 3 Amp
supplied by your local authorised agent should be used. Your battery pack
can be charged on or off the scooter. To remove the battery pack please
refer to, "Safety Warnings & User Guidance, Batteries".
1. Switch your scooter off at the tiller power switch.
2. Remove the battery pack from the scooter (if required).
3. Connect charger to the charging socket on the battery pack.
4. Ensure that the charger plug is dry and intact before connecting it to the
mains and switching it on.
5. A reset button is located on the battery pack to the left-hand side of the
charging socket. Please check that the button is pressed in.
Important safety warnings:
Do not expose any part of the battery pack to direct heat (i.e. naked
flame, gas fire).
Do not allow the batteries to freeze.
When charging always place on a hard surface in a room with
good ventilation. You should not charge your batteries in outdoor
conditions.
Always use recommended batteries from your local authorised agent.
The off-board charger must be kept dry in temperatures between -25°C
and 40°C and not be subjected to mechanical shock/damage.
In all cases, the charger must only be repaired by an authorised agent.
Fuses
There is a reset button on the left-hand side of the battery pack (Photo 20).
If a fault occurs, the button will pop out. Switch the scooter off, press the
button in and switch the scooter on again to reset.
There is also a fuse fitted in the mains plug of the battery charger, if this
blows, switch off at the mains and replace the blown fuse with a new fuse of
the same value.
28
Iss 2
Hide quick links:
Advertisement
Table of Contents
