Changing The Equalizer Mode (Auto Eq) Based On The Measurement Result; Time Alignment Adjustment (Time Alignment); Manually Adjusting Time Alignment - Eclipse CD5030 Owner's Manual

Changing the equalizer mode
(Auto EQ) based on the
measurement result
1
Press button [6].
Each time this button is pressed, the
equalizer mode is toggled as follows:
ON ↔ OFF
ON:
AUTO.EQ mode
OFF:
Manual mode
ATTENTION
You can set the 7-band parametric equalizer in
the AUTO.EQ mode to more effectively
configure the desired acoustic settings.
How to operate the Sound Adjustment Mode
Time alignment adjustment (Time
Alignment)
The delay time and level of the sound from each
speaker can be adjusted in order to correct any
phase mismatches in the sound resulting from
the listening position. You can automatically
adjust them if the
microphone (MEI-100) is connected.

Manually adjusting Time Alignment

Select "Time Alignment" by
1
pressing the [ ] or [ ] button.
2
Press the [ENTER] button.
The time alignment setting mode is
activated.
Press the [ENTER] button to select
3
the speaker band to be adjusted.
Each time the button is pressed, the
band changes in the following order.
Front Left → Front Right → Rear Left →
Rear Right → Non-Fader → Front Left
Adjust the time delay in the arrival
4
of the sound by pressing the [<]
or [>] button.
The delay time can be adjusted within
0.0 to 10.0 ms (0.1 ms for the main
unit).
[>]:
Increases the time.
[<]:
Decreases the time.
optional measurement
71
XII