When You Think There Is A Malfunction - Eclipse CD5030 Owner's Manual

Cd/usb multi-source receiver/built-in a2dp bluetooth wireless technology
Hide thumbs Also See for CD5030:
Table of Contents

Advertisement

When you think there is a malfunction

A slight difference in operation may be mistaken for a malfunction. Please check the items in the
following table first.
If the unit does not work, even after the appropriate remedial action has been taken, please contact
your dealer.
Mode
Problems
The sound is
difficult to hear
or cannot be
heard at all.
Power does not
come on.
All
Frequencies or
titles set in
memory have
been deleted.
There is no
guide tone.
The remote
control does not
work.
Causes
Is the volume sufficient?
Is the muting function activated (MUTE)?
Is the fader or balance control set to one
side?
Other probable causes include broken or
pinched audio-signal wires, a faulty
speaker, or a detached connector.
Are there too many electrical items
installed, causing a lack of available power?
Other probable causes include a run-down
car battery, a broken fuse, or pinched or
broken power or communication wires.
Has the car battery been disconnected for
repairs or inspections?
Are there too many electrical items
installed, causing a lack of available power?
Other probable causes include a run-down
car battery, a broken fuse, or pinched or
broken power or communication wires.
Is the guide tone set to OFF?
Are the batteries low?
Are the batteries installed correctly
(reversed polarity)?
Is direct sunlight hitting the remote control
light receptor?
There may be a malfunction in the remote
control unit.
If you have a question:
Remedial action
Turn up the volume.
Cancel the muting (MUTE)
function.
Readjust the fader and
balance controls to normal
positions.
Have your dealer check the
problem.
Have your dealer check the
problem.
Have your dealer check the
problem.
Reenter the frequencies or
titles into memory.
Have your dealer check the
problem.
Have your dealer check the
problem.
Reset the guide tone to ON.
Replace the batteries.
Reinstall the batteries
correctly. (correct polarity.)
Use the remote control in
closer proximity to the
receptor.
Have your dealer check the
problem.
Refer
to
page
17
17
62
41
79
44
44
XXI
107

Advertisement

Table of Contents
loading

Table of Contents