Lexmark 210 User Manual page 229

Understanding the printer menus
Use
Timeouts
Hibernate Timeout
Disabled
20 minutes
1 hour
2 hours
3 hours
6 hours
1 day
2 days
3 days
1 week
2 weeks
1 month
Timeouts
Screen Timeout
15–300 sec
Timeouts
Prolong Screen Timeout
Off
On
Timeouts
Print Timeout
Disabled
1–255 sec
Timeouts
Wait Timeout
Disabled
15–65535 sec
To
Set the amount of time the printer waits before it enters Hibernate
mode.
Notes:
•
When the Hibernate Timeout timer expires, the printer uses
Ethernet connection to check the value of Hibernate
Timeout on Connection.
•
If Hibernate Timeout on Connection is set to Do Not
Hibernate, then the printer never automatically hibernates.
•
If Hibernate Timeout on Connection is set to Hibernate, then
the printer follows the Hibernate Timeout value, except
when it is set to Disabled.
• 3 days is the factory default setting.
Set the amount of time in seconds the printer waits before
returning the display to a ready state.
Note: 30 sec is the factory default setting.
Set the printer to continue the specified job without returning to
the home screen when the Screen Timeout timer expires.
Notes:
•
Prolong Screen Timeout appears only in touch‑screen printer
models.
• On allows the user to reset the Screen Timeout timer instead
of returning to ready state.
•
Off follows the normal Screen Timeout value.
•
Off is the factory default setting.
Set the amount of time in seconds the printer waits to receive an
end‑of‑job message before canceling the remainder of the print
job.
Notes:
•
90 sec is the factory default setting.
•
When the timer expires, any partially printed page still in the
printer is printed, and then the printer checks to see if any
new print jobs are waiting.
• Print Timeout is available only when using PCL emulation.
This setting has no effect on PostScript emulation print jobs.
Set the amount of time in seconds the printer waits for additional
data before canceling a print job.
Notes:
•
40 sec is the factory default setting.
• Wait Timeout is available only when the printer is using
PostScript emulation. This setting has no effect on PCL
emulation print jobs.
229