Table of Contents
Advertisement
Adjust speaker output to balance front speaker sounds with those from each of the other
speakers in the seating area.
Make adjustment after detecting speakers automatically (á page 10).
Press [SPEAKERS A] on the unit to switch "
(Press [SPEAKERS A] or [SPEAKERS B] to switch "
on when bi-wire speakers are connected.)
1 Press
Adjusting speaker
volumes
How speakers are displayed
L :
Front left
C :
Center
R :
Front right
RS : Surround right
LS : Surround left
SBR : Surround back right
2 Press
SBL : Surround back left
SB : Surround back
(If you connect one
3 Press
surround back
speaker)
SW (SUBW ) : Subwoofer
4 Press
Repeat steps 3 and 4 to adjust the level of each speaker.
• Only the adjusted speaker produces the test signal in steps 3 and 4.
• Connected speakers start producing the test signal again in the above
• Press [TEST, –AUTO] to stop the test signal.
You can adjust the output level while playing sources. You can adjust the level according to your
preference by thickening or thinning the ultra bass, for example.
Press
Adjusting the
• Select "
subwoofer level
• Sound can be distorted if you raise the volume while the subwoofer level is high. Reduce the subwoofer
• Adjust the output level by taking steps described in "Adjusting speaker volumes" (above) when you
Press
• "MUTING IS ON " scrolls across the display while the volume is muted.
Silencing speakers
• Press the button again to cancel the operation.
temporarily
Muting is cancelled when you turn the unit off or adjust the volume.
Press
Dimming the
• Press the button to dim the display. The light above [INPUT SELECTOR] and [VOLUME] goes off.
display light
• Press the button again to cancel the operation.
(Dimmer)
Refer to page 31 for adjusting the brightness on the unit.
AUTO
TEST
• A test signal is output from one speaker at a time for two
seconds in the following order.
L
C
R
RS
SBR
L
C
R
RS
(When you connect one surround back speaker)
• Speakers not connected (á pages 9, 10, 22 and 23) or set as
unconnected in "Setting speakers and their sizes" (á page 33)
do not output test signals.
VOLUME
to adjust the volumes of front speakers
to the normal listening level.
LEVEL
to select a speaker for adjustment.
• Speakers switch in the following order each time you press the button.
C
RS
SBR
SBL
C
RS
SB
(When you connect one surround back speaker)
to adjust the volume of the
selected speaker.
order 2 seconds after both steps.
SUBWOOFER
to select a level.
" to stop output.
---
Note
level if this occurs.
wish to make detailed settings.
MUTING
Note
DIMMER
Note
" on.
A
"
A
B
SBL
LS
SW
SB
LS
SW
LS
SUBW
LS
SUBW
Note
If you select "SPEAKERS B" only,
the test signal will not be output.
Speaker
Volume range:
- - dB (minimum),
-79dB to 0dB (maximum)
Speaker
Adjustment range:
–20dB to +10dB
Factory setting: 0dB
SUBW only:
↔
↔
MIN (minimum)
1 to 29
MAX (maximum)
Factory setting: 20
Adjustment range:
--- (off), MIN (minimum), 5, 10, 15,
20, 25, MAX (maximum)
Factory setting: SUBW 20
29
RQT8743
Advertisement
Table of Contents
