Table of Contents
Advertisement
Remote controlling a TV or DVD recorder etc.
Aim the remote control at the
equipment you wish to operate.
RECEIVER
AV
SYSTEM
TUNER
CD
BAND
DIRECT
0
TUNING
DISC
SKIP
STOP
PAUSE
DRIVE SELECT
ENTER
SUB MENU
SUBWOOFER
OFF
LEVEL EFFECT VOL
NEO : 6
SFC
MUSIC
MOVIE
42
RQT8743
Remote controlling a DVD recorder
To switch the unit's
input to "DVR "/
To switch the remote
RECORDER
control to the DVD
TV
DVD
recorder operation
PLAYER
VCR
BD/DVD
mode
ANALOG 6CH
To turn the DVD
CH
recorder on or off
VOLUME
To start playback
-/- -
SLOW/SEARCH
To skip a track or
PLAY
chapter
MANUAL SKIP
To search through the
disc
To play in
RETURN
slow-motion
TV
DIMMER
To show the direct
TV/AV
navigator
AUTO
(or the top menu)
TEST
MUTING
To show a sub menu
To show the
FUNCTIONS window
(while stopped)
To return to the
previous screen
To select an item
Press to select after
pressing [DIRECT
NAVIGATOR, TOP MENU],
[S, SUB MENU], or
[FUNCTIONS].
When operating a Panasonic DVD recorder
using the supplied remote control
Change the control setting on the supplied
remote
recorder's remote control mode.
control mode in its operating instructions.
1 Press [DVD RECORDER].
2 Press and hold [ENTER] together with
[1], [2], or [3] for 2 seconds or longer.
• [Mode 1], [Mode 2], or [Mode 3] is set on
the remote control according to the
pressed button.
• The factory setting is [Mode 1].
RECORDER
DVD
Do not forget to
press this before
operating a DVD
recorder.
AV
SYSTEM
PLAY
SKIP
SLOW/SEARCH
PAUSE
SLOW/SEARCH
SUB MENU
RETURN
control
to
match
the
DVD
Confirm the DVD recorder's remote
To confirm the
selected item
To select a track or
chapter directly
• Some of the models
require you to press
[ENTER] to confirm after
pressing number buttons.
To pause
To move forward or
backward frame by
frame
To skip 30 seconds
forward
To switch DVD
recorder drives (HDD,
DVD drive, and SD
drive etc.)
To select a channel
(When you make a
selection in rising or falling
order)
To select a channel
(When you select a
channel directly)
To stop playback
When DVD recorder drives do not switch
The condition may mean the DVD recorder does not
recognize the signal this unit's remote control transmits.
Switch the drives again after changing the
signal in the following procedure.
1 Press [DVD RECORDER].
2 Press and hold [ENTER] together
with [8] for 2 seconds or longer.
• To return: In step 2 above, press and hold
[ENTER] together with [9] for 2 seconds
or longer.
Note
When you operate a DVD recorder with
built-in VCR, press [DRIVE SELECT] to
select a choice other than VCR.
ENTER
0
-/- -
PAUSE
PAUSE
MANUAL SKIP
DRIVE SELECT
CH
0
-/- -
STOP
Advertisement
Table of Contents
