Table of Contents
Advertisement
Confirming audio output from speakers and adjusting volumes
Through these steps, you make sure each of the connected speakers makes audio output.
Adjust the output level from each speaker and the output level from the front speakers to achieve balance in the listening-
viewing position.
1
Select [SPEAKERS A].
SPEAKERS
Press
A
When using a BI-WIRE connection
Select "YES " in "Setting bi-wiring connections" (á page 31).
SPEAKERS
Press
A
Check the test signal output.
2
TEST
Press
• A test signal is output from one speaker at a
time for two seconds in the following order.
L → C → R → RS → SBR → SBL → LS → SUBW
or L → C → R → RS → SB → LS → SUBW
(When you connect one surround back
speaker only)
• Speakers not connected (á pages 11 and 14)
and others manually set as absent
(á page 31) do not produce the test signal.
Adjust the volumes of front
3
speakers to the normal
listening level.
Press
VOLUME
Select a speaker for
4
adjustment.
LEVEL
Press
speaker.
Adjust the volume of the
5
selected speaker.
Press
Repeat steps 4 and 5 to adjust the level
of each speaker.
Stop the test signal.
6
TEST
Press
(á page 11)
or
and select a
When only the SPEAKERS A
setting is selected
SPEAKERS
A
• If you select SPEAKERS B only, the test signal will not be output.
SPEAKERS
BI-WIRE
A
B
L :
C :
R :
RS :
LS :
SBR :
SBL :
SB :
SUBW : Subwoofer
Volume range:
-- dB (minimum), -79 dB to 0 dB (maximum)
Adjustment range:
-10 dB to +10 dB (Factory setting: 0 dB)
SUBW only:
MIN (minimum) ↔ 1 to 19 ↔ MAX (maximum)
(Factory setting: 10 )
• Only the adjusted speaker produces the test signal in steps 4 and 5.
Connected speakers start producing the test signal again in the
above order 2 seconds after both steps.
When SPEAKERS A and SPEAKERS B
settings are selected
or
SPEAKERS
A
B
How speakers are displayed
Front left
Center
Front right
Surround right
Surround left
Surround back right
Surround back left
Surround back (If you connect
one surround back speaker)
15
RQT8549
Hide quick links:
Advertisement
Table of Contents
