Wv-Cu50 Remote Controller - Panasonic WJ-HD500A Operating Instructions Manual

WV-CU50 Remote Controller

LOCK
&1
SPOT
MULTISCREEN
&2
MULTISCREEN
SELECT
&3
&4
SEQUENCE
&5
&6
GROUP
SELECT
&7
INDEX
&8
ALARM
SEARCH
&9
DISPLAY
*0
&1 Lock Button (LOCK)
Toggles to enable or disable the button lock function on
both front panels of the Disk Recorder and Remote
Controller.
The LED indicates the status as shown below.
On: The button lock is enabled.
Off: The button lock is disabled.
While On, the button lock will be released only if the
preset password is entered in the password inquiry win-
dow.
&2 Monitor Selection Button
(SPOT/MULTISCREEN)
Selects either the Spot or Multiscreen Monitor for which
you wish to control the display on the screen.
The LED indicates the status as shown below.
On: The Spot Monitor is selected.
Off: The Multiscreen Monitor is selected.
10
*3
*1 *2
Remote Controller
LINK
1 2 3
COPY
5 6 7
REC
PREVIEW
9 10 11
EL-ZOOM
13 14 15
STOP PLAY/ PAUSE
REV FWD
ALARM
RESET
REC
STOP
WV-CU50
SET
4
*4
*5
8
12
*6
16
*7
REC
*8
*9
(0
(1
(2
&3 Multiscreen Selection Button
(MULTISCREEN SELECT)
Selects the multiscreen pattern to be displayed on the
Multiscreen Monitor.
Pressing this button will change the screen pattern as
follows.
4 → 7 → 9 → 10 → 13 → 16 → 4 screen segments
&4 Recording Preview Button (REC PREVIEW)
Use this button to display the playback image with the
live images on the Multiscreen Monitor.
The LED indicates the status as shown below.
On: The selected playback image is displayed
Blinking: Prompts you to select the numeric button for
displaying the playback image.
&5 Sequence Button (SEQUENCE)
Runs the assigned sequence on the selected monitor
screen for the specified duration.
During the sequence, pressing this button will pause
the sequence that is being run on the monitor screen.
The LED indicates the status as shown below.
On: Sequence is being run.
Blinking: Sequence is in pause mode.
REMOTE
(3