Zanussi ZCM5160 Instruction Book page 22

Replacement of the nozzles
Every appliance has spare nozzles for every gas.
The whole of every nozzle is marked in microns on
the nozzle.
For changing the nozzles:
1. Remove the pan support;
2. Remove the burners;
3. Using a socket spanner 7 unscrew the
nozzles (fig. 24) and replace them with those
required for the type of gas in use (see table
no. 2).
Put in place the burners and the pan supports.
Adjustment of minimum
burners.
When changing the gas type watch that the
minimum level be correct. A regular flame at
minimum level is about 4 mm; check that, turning
quickly the knob from the maximum to the
minimum position, the burner doesn't go out.
Flame adjustment
1. Light the burner
2. Turn the knob to minimum level
3. Pull out the knob
4. Unscrew or screw the pin (on the right of tap
axle, fig. 25) until a regular small flame is
obtained. For butane-propane gas, screw
totally the pin clockwise
5. Put in place the knob
6. Turn the knob several times from maximum to
minimum level for verifying the flame steadiness.
level of plate
fig. 24
fig. 25
21