Zanussi ZCM5160 Instruction Book page 19

Flexible pipe
Flexible pipe (mechanic connection) max
length 1.5 m;
We advice to use a flexible pipe, according to
the national rule in force, not shorter than 1 m,
depending on the position of the tap;
Connect one end of the pipe to the blocking
tap, than, before placing the appliance between
the furniture, connect the other end to the pipe
extension, inserting a gasket.
Place the cooker checking that the loop made
by the flexible pipe develops in the sanitary
empty of the furniture.
Rigid pipe
Rigid pipe with screw nut.
2. For cylinder butane propane gas:
We advise you to use f l exible pipe according
to the national rule in force of minimum 1 m;
this length is chosen depending on the
position of the connection to the gas supply;
For the old butane installations you can use a
flexible rubber pipe of max 1,5 m and 6 mm
diameter, mounted with the special butane
holder ;
Fix it well by means of a collar for each end.
The appliance ran be connected to the gas supply,
right or left side, by one print of connection. The
end of the distributing pipe is threaded.
It is necessary to route the connecting hose
(flexible) at the back of the appliance as shown in
the diagram. Ensure that the rubber hose is not in
contact with any part of the hatched area shown in
the diagram. The hose has to be fixed in the
support by means of the clamp supplied. The hose
should not have narrow curves or throttlings.
Check tightness with soapy water.
Electrical connection
Important
Any electrical work required to install this
hob should be carried out by a qualified
electrician or competent
accordance with the current regulations.
THIS COOKER MUST BE EARTHED.
The manufacturer declines any liability
should these safety
observed.
Before switching on, make sure the
supply voltage is the same as that
the rating plate.
18
person, in
measures not be
electricity
indicated on
Pipe
flexible
fig.20
Fitting
Holder
butane
Flexible
rubber
Necklace
fig. 21
fig. 22
Pipe
flexible
connection of
flexible hose
clamp