Operating The Dual Alarm System - Timex Ti700 Quick Start Manual

Note: The Ti700 has a dual alarm feature allowing you to wake to the iPod / Buzzer or Radio. The buzzer alarm will still
sound in the event of power failure, if backup batteries are installed.
Setting the Alarm(s)
1. Press and hold the
the alarm time. Remember to set the correct AM or PM time.
2. Press the Alarm 1 Button again or wait for 10 seconds. Alarm 1 is now armed, indicated by the numbered alarm
clock icon.
3. To set Alarm 2, just repeat steps 1 and 2 above but using
4. Set the ¹ Wake-to Switch located on the back of the unit to wake to radio or iPod/Buzzer (if no iPod is
docked/detected, the alarm source will be the buzzer alarm). Both alarms (1 and 2) will wake you to same sound source.
NOTE:The radio alarm will wake you to the currently tuned band and station.
Review, Arming and Disarming Alarm (Turn Alarm Function On and Off)
1. Press the Alarm 1 (or Alarm 2) Button once.The display will show the current alarm time on the bottom part of the
display for alarm time review.
2. During alarm review, press the button again to arm or disarm the alarm. When the alarm is armed, the related alarm icon
appears in the display.
Resetting the Alarm to Come on the Next Day
1. When the alarm is sounding, press the
come on the following day.
Snooze
1. Press the Snooze/Dimmer Button after the alarm sounds. The alarm will be silenced and come on again approx. 9
minutes later. Snooze can be pressed several times during the 1 hour alarm cycle.

Operating the Dual Alarm System

Alarm 1 Button for 2 seconds until the display flashes. Press the
Alarm Reset/Power On/Off Button to stop the alarm sound and reset it to
Alarm 2 Button.
<< or >> Button to set