Hardware Installation - D-Link DCS-1000 Manual

Hardware Installation

This section describes the Hardware installation procedure for DCS-1000.
1. Connect an Ethernet cable
Connect an Ethernet cable to the
network cable connector located
on DCS-1000's rear panel and
attach it to the network.
2. Attach the external power supply
Attach the external power supply
to the DC power input connector
located on DCS-1000's rear panel
and is labeled DC 5V and connect
it to your local power supply.
Note:
Confirm power source is supplied
from the LED indicators label Power
on DCS-1000 is illuminated.
9