How To Snap Shot A Camera; Snap Shot Camera; How To Adjust The Property Setting; Property Setting - D-Link DCS-1000 Manual

How to Snap shot a Camera

Snap shot Camera

To snap shot a camera you must highlight the camera you wish to snap shot
from the list view format. From the menu bar select "Camera" > "Snap
shot". A Save Image dialog box will appear for you to save the snap shot
picture.
A second alternative is from the viewing mode either 1, 4, 9, 16 cameras click
on the icon located on the upper left corner of the screen and a case sensitive
menu will appear and select the "Snap shot" icon. A Save Image dialog box
will appear for you to save the snap shot picture.
Note:
Alternatively you can click the Snap shot icon as illustrated or use the hot
key "F5 ".

How to Adjust the Property Setting

Property Setting

"Property" is initiated by selecting "Camera" > "Property" and a dialog
box will appear allowing settings of Web Configuration and upgrade firmware
(Please refer to the appendix for detailed information). The Camera
Property dialog box will appear for you to select the desired options from the
tab selections to Configure the camera as shown below.
General
Allows settings for the camera name, location and administrator information
such as administrator ID and password. Please refer to the Web Configuration
section under "System Administration – System" for further details.
45