Yamaha RAPTOR 700R Owner's Manual page 104

1
2
3
4
5
6
1. Coolant reservoir cap
2. Hose
7
7. After draining the coolant, thoroughly flush the
8
cooling system with clean tap water.
8. Replace the coolant drain bolt washer if it is
9
damaged, and then tighten the coolant drain
bolt to the specified torque.
10
Tightening torque:
11
Coolant drain bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
9. Connect the coolant reservoir hose.
10. Pour the recommended coolant into the reser-
voir to the maximum level mark, and then in-
stall the reservoir cap.
1
11. Pour the recommended coolant into the radia-
tor until it is full.
Antifreeze/water mixture ratio:
1:1
Recommended antifreeze:
2
High-quality ethylene glycol antifreeze con-
taining corrosion inhibitors for aluminum en-
gines
Coolant quantity:
Radiator capacity (including all routes):
1.61 L (1.70 US qt) (1.42 Imp.qt)
Coolant reservoir capacity (up to the maxi-
mum level mark):
0.25 L (0.26 US qt) (0.22 Imp.qt)
ECB00401
CAUTION:
G
If coolant is not available, use distilled water
or soft tap water instead. Do not use hard wa-
ter or salt water since it is harmful to the en-
gine.
G If water has been used instead of coolant, re-
place it with coolant as soon as possible,
otherwise the cooling system will not be pro-
8-17