Getting Started; Setup; Connecting Power To Base Unit; Installation And Charge Of Battery - VTech Cordless Telephone Manual

Setup

Connecting Power to Base Unit

1. Choose a location for the base
near an electrical outlet and a
telephone jack. This phone requires
a modular telephone jack and a
standard electrical outlet (110V
AC) not controlled by a wall switch.
2. Plug the DC connectors to the base. Plug the AC adaptors into an electrical
outlet. Connect the telephone line cord to the jack on the base, and the other
end to a modular telephone jack, as illustrated on the next page.

Installation and Charge of Battery

1. Install the battery. Use only VTech batteries.
a) Remove battery com-
2. If the phone will not be used for long periods of time, remove the battery to
prevent possible leakage.
partment cover by
pressing on the in-
dentation and sliding
downward.
b) Align the two holes in the plug with the
socket pins, then snap the plug into place.
c) Place the battery in the compartment
with the wires in the lower right corner.
d) Replace the battery compartment cover.
e) If the battery is not already charged,
place the handset in its base or charger
and allow to charge for 10 -12 hours (or
over- night). After that, be sure to place
the handset in its base or charger when
not in use to ensure maximum daily
peformance.
6